Questions & Answers for: Lexus ES 300 valve covers

1996 LEXUS ES300 3.0L Need to see how the vacum lines are connected to the Intake manifold. They were removed when replacing the Valve cover gaskets. Thank you, Arthur i have prolem with my car p0753

...fine. could it be the oil pump? Not the oil pump, the most likely cause is the intake and exhaust valve seals, this accounts for the smoke on start up My Lexus is doing the same thing. I had it ...

Valve cover and Oil pan bolt torque I'm replacing oil pan gasket and valve cover gasket, looking for torque on bolts for both. Also any series of tightening order if there is one. Inside to outside ...

...have to remove the intake air plenum to gain access to the firewall side of the engine where the valve cover is located. If you buy a Haynes repair manual for the 92-96 camry, it covers the

spark plugs where are they located on a 1992 lexus es 300 there are 6. 3 are located in front valve cover and 3 are located under upper air intake in the rear valve cover.they can be removed without ...

where is the pcv valve on the 2000 lexus es300? The books says it is in the valve cover but I can't see it? It should be conected to the a valve cover via a short hose.. I have replaced the PCV valve ...

...I hit the first stoplight, while idling it was smoking really bad. Excessive oil residue from the valve cover breather to the intake. Uses 1qt about every 150 miles (some due to oil leak from ...

valve cover gasket leak on 95 lexus es300. how do i fix Take the valve cover bolts off then get the new gasket on or use permatex gasket glue than put it back together

how to change valve cover gasket and thermostat on 1992 ES300 the thermostat its located in water out hose near to a/c compressor, to change valve cover, front of engine remove the plastic cover with ...

...valve covers. already replaced spark plugs. mechanic said valves need adjusting. what do you think? Ask him how do you adjust hydraulic tappets which are self adjusting. It is more like failing ...