Question about 1987 Bronco
trying to replace the valve cover gasket on the passenger of my 1987 ford bronco and cannot seem to get to it? trying to replace the valve cover gasket on the passanger side of my 1987 ford bronco 302
...many times the crankcase is not venting properly and the PCV valve needs replacment it is inexpensive enough just replace the PCV valve located on one of the valve covers it has a hose going to
...and my idle goes up and down. also do i have t pull the top part of the intake to do the right valve cover gasket The egr is only active when the engine is under load, it should not make a ...
can't find where the pcv valve goes on a 1990 Ford Bronco II, PVC VALVE SHOULD BE ON VALVE COVER OR ROCKER ARM COVER.
...and there is milky looking oil on the end of the dipstick and in the breather that is on top of the valve cover going to the air filter box. possible intake manifold gasket leaking into engine Sounds ...
Location of PCV valve IN THE TOP OF THE RIGHT SIDE ROCKER COVER TOWARDS THE REAR OF THE ENGINE UNDER THE PLENTUM
valve covers on my 1990 bronco 2 v-6 No torque specs. Don't use sealer, that can cause the gasket to slip. Put cover in place, start all bolts, loosely snug all, hand tighten from bottom two, top two,
How do I put oil in a Ford Bronco? There is a cap on one of the valve covers. You pour the oil in that.
burnt oil smell when driving 96 ford bronco when driving this vehicle there is an unexplained burnt oil smell. Not sure where its coming from. leaking valve cover gaskets
351w loss of power and smoke coming from valve covers Check into clogged cat converter. Also Overheating.
Usually answered in minutes!
227 Questions
224 Questions
178 Questions
137 Questions
124 Questions