Questions & Answers for: Kia valve covers

...valve covers pop off the right and left side Valve cover facial covers, now on the drivers side Valve cover left side rear move your fingers slowly where the valve cover sits on the head...Can you ...

how to fit kia sportage valve seals my kia sportage runs very rough and i have been told it could be the valve cover gasket did they mean valve stem seals and if so how do you fit them ? no its the ...

valve cover torque Whats is the amount of torque I should apply to tighten the valve cover bolts? thanks -Alex The spec for the valve cover fasteners is 10 nm (about 7.2 ft/lbs) and the sequence of ...

Where's the PCV Valve Located? In the front valve cover, facing the valve cover, it's by the right end of the valve cover. There is a vacuum hose connected to it.

...covers the top of the valve cover and then you will see the sparkplug holes, there will be sparkplug wires going to each plug or a coil for each plug but you will see the location once you remove the ...

why is oil in sparkplug wells? there are o-rings that are under the valve cover that seal the valve cover to the cylinder head, they are leaking and allowing oil to leak from under the valve cover ...

...valve covers off, two (rockers) were off on left side, cams now loose, valves all up, cranks still not turning??? timing belt broke did you chk the front take off plastic covers and see but very bad ...

I can't remove the valve cover on my 99 kia sportage. I am "simply" trying to change the valve cover gasket, and the valve cover won't come off. I believe I removed all the bolts

2007 Kia Spectra. What's the torque specs for the valve cover gasket. Gasket is leaking. It ranges between 50 and 100 lbs. depending on the material, engine model, and bolt placement point. Use the ...

Kia Sorento generation JC 3.5 V6 4WD valve cover torque settings please? In the link and a video as well. NOTE: they are POUND INCH not Foot Pounds. Torque Pattern for Valve Cover? - Kia Forum ...