Questions & Answers for: valve cover gasket volvo s40

...cover undo valve, renew gasket and re install. ade 13 years volvo tech its sitting right up front right side easy to replace star scewdriver and vice grips or pliers to remove plastic cover and start ...

cover and you will see the valve situated on top of the head,undo the connector and remove the 4 bolts and the valve will come off,alittle bit of oil will come out on removal. remove gasket and ensure

...to the oil change routine. The VVT solenoid on the top of the valve cover gets clogged with thickened or sludged oil. Replace the VVT solenoid and gasket with a new unit and clear the codes. blow it ...

volvo 2005 s40 There will be marks on the pulleys that match up with marks on the top plastic cover that goes over them. Sometime the marks on the pulleys are hard to see unless you look very closely.

...volvo s40 2005 under the hood towards the front of the car there is a rectangular cover, with 2 phillips screws holding it down. take out the 2 screws then you have to yank up on the cover cuz its ...

...Check spark plug, could be defective How many Km-is on the car? ok the valve cover gasket needs to be replaced it will come with spark plug gaskets that will stop the oil leaking in to the spark ...

...trans front cover and you will see the solenoids mounted to the valve body. NOTE: DON NOT USE aftermarket parts for any of the valves. Also use the Volvo pan sealer only. Save yourself the

...and after head gasket changed Make the timing belt is installed properly, otherwise all the intake valves will be bent because it is a high interference combustion chamber. Check compression after ...

I have a 2005 volvo s40 1.8. am i correct in thinking the iac is located in the throttlebody cover? Yes, but there is a TPC sensor too!!!

...valve cover on most engines. They are, carefully, removed by tugging/pulling up on them. Also, replace the rubber grommet that 'seals' it into the valve cover. Good luck and keep me informed; if you ...