...engine cold.. use firing order 1, 3 ,2, 4.. cyl #1 on tdc @ crankshaft, check adjust valve on using locknut / screw. #3 next #2 after that #4 last. bring each cyl to tdc in = 10in ex= 14in good ...
valve thats down subtract from 9 and then adjust that number ,this system works on all engine regardless of what the haynes book says ,6 cyl engine then its 13 ,and a 8 cyl engine then 17 ,in cases of
valve was leaking, replaced it so now it idles. Before EGR, just wouldn't idle. Fuel filter recently replaced. Could one of the electrical components on the carb cause this problem? It started
...Adjust or replace the cable for the hill-holder system. The short cable runs from the Pressure Hold Valve unit (mounted directly below the brake master cylinder) to the clutch release lever. The PHV ...
Usually answered in minutes!
97 Questions
60 Questions
48 Questions
48 Questions
40 Questions