Questions & Answers for: Bosch vacuum wires

power cord Power cord pulled completly out of canister.Removed two screwes that where under filter bag lid, Now where are the othere ones hidden & how to get to them ?? Help. Yo need to find the third

...vacuum does not turn on? I had the same problem. I ordered a new switch from a local appliance place part#417915 (also try 54542), but it can be found on-line for ~$2+shipping. There are 11 screws to ...

...vacuum and it runs but the brushes don't turn can you help? open the head. there is a dc 120 v motor with a belt. check for ac power going in to the rectifier board and dc comming out. sometimes the ...

...my vacuum has no power when I plug it in its a problem with the power switch you can wire nut the wires together but I have been looking for parts myself. Press safty button and wait for 2

vacuum cleaner I am not able to remove the covers which enclose the switch. Can anyone help me I had the same problem. I ordered a new switch from a local appliance place part#417915 (also try 54542),

Dirt Devil M082475 12 AMP cannister vacuum power-head problem I've narrowed the problem down to the power line that runs from the cannister to the power head (through the main hose). If I plug the ...

...vacuum). Even though the yellow coating of the wires were not cut through, you could tell they looked a little skimpy and sure enough, when held to the light you could tell the wires were not ...

vacuum? If the plug was rotated, it is possible that the wires inside the cord may have frayed insulation and are making contact with each other. If it is the plug or the plug end of the cord, you can

when I turn on my right turn signal my left turn signal blinks sounds like soemone has been in your wiring at the tail light. if they switched the two wires for the turn signals when they put it back ...

how to replace vacuum cleaner plug Do you need to replace just the male plug connector or the entire length of wire too?