vacuum line connect to under the hood for my heat and air vent change for a 1985 Jeep Cherokee 4 cyl, or 6 cyl.? No fitting at base area of carburetor, or at back of intake manifold near where line is
...vacuum lines under the dash as well as the vacuum diaphrams that control heater door operations. if you have a hand vacuum pump you can check all these at (previous found) intake connection for the ...
...vacuum line connected to the diaphram again and **** on the line.. The vehicle should die or run really bad. If it does this then you cleaned it correctly. You should remove the EGR valve and scrape ...
...vacuum line from the brake booster is connected to a rubber hose, which goes to a metal tube. This goes towards the back of the intake. The part on the intake was only hose pushed on the metal tube, ...
...intake manifold. It also has a vacuum or electric control lines. The link shows what it looks like: ...
...vacuum line from the throttle body. Accelerator and the cruise control cables with the bracket from the throttle body. Remove or disconnect the following: Upper intake manifold bolts and stud. Clean ...
...to connect to the intake manifold, check it for breaks or leaks, as with all the other vacuum lines and connectors.Fords are SUPER sensitive when it comes to intake manifold absolute
...vacuum lines on a 1983 yamaha maxim 650 The only vacumn lines on a Maxim 650 is the small line from the fuel petcock that turns it on when there is intake suction. It can be connected to any intake ...
...vacuum lines between it and the intake manifold and a third vacuum (soft) line between the modulator and the EGR valve itself. EGR Vacuum Modulator EGR valve (arrow) is shown adjacent tosimilar EGR ...
vacuum ports on the 4.2 , 6 cyl. engine that I know of: One is on the top of the intake manifold, near the back by the throttle body; it has the MAP (manifold absolute pressure) sensor plugged into it
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions