Questions & Answers for: Chevrolet Corvette vacuum leak

Question about 1998 Corvette

2 Answers

...If there is a vacuum leak or hissing try to locate it. Always check for good vacuum from engine threw vacuum tank to heater controls. Lot of plastic vacuum line that break or crack or come ...

Ad

...it only stays on vent at all times can u advise please ? smoke in Deetroit First, check that the vacuum line from the engine going into the dash is connected and not leaking. Then, check for

Ad

vacuum leaks down when the engine is off. Probably have a leak in the headlight actuators, will need to replace or rebuild one or both of them, not a big problem for them to pop up some people just do

...leak on top of the engine at a device where one of the fuel lines come up from under the car. This device also looks like it has a vacuum hose on it. After this device the fuel line travels along the ...

...hard to press in The air leak you hear is vacuum leaking from booster and also the hard pedal is also due to the booster, replace the vacuum brake booster and this will solve your problem. good

Question about 1985 Corvette

1 Answer

...vacuum leak on the intake manifold on the manifold or around the carb.. If you think this is a cause, spray starting fluid around the manifold when at idle if the engine acts up when spraying in a ...

...a/c control is electric for temp control and vacuum for mode control when a leak occurs it defaults to defrost floor .look for a leak or broken vacuum line first then control panel then mode

...for a vacuum leak inside the car at the switch, (headlight switch)  .Make sure all lines are good and have no leaks, you will need to make sure the hinges to lights are free and not binding

...vacuum leak not allowing the vacuum operated vent/duct inside your instrument panel to operate. Check all of your rubber vacuum hoses in the engine compartment for leaks, cracks or breaks . your ...

...vacuum leak or any vacuum leak? my engine wont start after installing a new high rise intake and new holley street avenger 670 carb. Recently i replaced my edelbrock performer intake with a high rise ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...