Question about WindTunnel V2 U8148-900 Upright Vacuum
...utility knife from the outside of the nozzle housing but you must inspect the head continually or you will end up with a ruined brush roll. THAT OR A HAIRCUT FOR THE OFFENDERS. This is only part of ...
...utility knife and wire cutters and then screw the fresh hose end back onto the handle stem. The hose should also be glued from the inside (after cleaning with a dry cloth) with a contact type cement ...
utility knife to carefully clean off all hair and other debris. Make certain that the roller rolls smoothly and easily. 6:Place the new belt around the roller, fitting it into the groove in the middle
Question about Fusion Plus Cyclonic Upright Vacuum Vacuum
utility knife to carefully clean off all hair and other debris. Make certain that the roller rolls smoothly and easily. 6:Place the new belt around the roller, fitting it into the groove in the middle
Question about Featherlite Bagless Vacuum M085845Vacuum
...knife or a utility knife making a single cut across the length of the roller is a good way to start. Then it is just a matter of pulling the strands or fabric and hair, etc., off. I like to inspect ...
utility knife for easy carryout, then if you need to remove the tack strip as well use a pry-bar but be careful as the tack strips are very sharp I have always just removed some molding at the edge of
Question about Featherlite Bagless Vacuum M085845Vacuum
...off using a utility knife, then cleaned and recemented to the other hose. Not an easy job, but it can be done. A vacuum cleaner repair shop might be able to accomplish this task for a reasonable
Question about Featherlite Bagless Vacuum M085845Vacuum
...making sure the vacuum conduit (the 'tube') is clear of debris. String, thread, pet-hair... loose, stringy material may snag and clog the vacuum. use a utility knife to cut it free before
Question about Featherlite Bagless Vacuum M085845Vacuum
...is sometimes needed to open a Shark vacuum cleaner. If your unable to remove the bottom plate to clean the roller brush, take a utility knife and cut straight down on line in the brush (see
Question about Featherlite Bagless Vacuum M085845Vacuum
all vacuum cleaners will have a line where to cut. In this case, you can still use a utility knife just be more cautious where your cutting and not too deep. Make your cuts on both sides of the roller
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions