Questions & Answers for: Chevrolet TrailBlazer utility knife

is there any recourse from a used car dealer for selling me a car 3 mos ago that is throwing codes now that will require a new engine on a 06 chev trailblazer. bought as is. you can contact the (USED ...

Ad

...shroud will knock a ton of time off in installation and re-installation. I just scored the plastic with a utility knife, then used dykes, popped right out in perfect size with one cut with the

Ad

Power windows and locks stopped working but only on the driver side open driver's door, and check wiring between the door and hinge pillar due to open and closing the door, the wiring will break, use ...

Question about 2002 TrailBlazer

1 Answer

How to change sparkplugs. What steps are involved? This ignition system utillizes COP (coil on plug) ignition, therefore there are no traditional plug wires. Insted there is an ignition coil mounted ...

Question about 2002 TrailBlazer

2 Answers

...shroud will knock a ton of time off in installation and re-installation. I just scored the plastic with a utility knife, then used dykes, popped right out in perfect size with one cut with the

Question about 2002 TrailBlazer

1 Answer

when i turn on my a/c the idle speed lowers until engine turns off. There is a solenoid that increases the rpm w/ ac is on it ether is not getting a signal or it is not able to utilize the signal.. it

...an internal cooler. To add to the above solution, if you are pulling any trailer short of a small utility trailer, you should install an external cooler.  All automatic transmissions have a ...

how do you remove a liftgate handle on a 2005 trailblazer handle on my trailblazer broke so just need to know how to replace it. any help will work thanks hi mate you should be able to remove handle .

steering column buzzing and wont let me pull key out steering column is buzzing and wont let me pull key out 2 things that are common, 1 is your ignition switch is going bad, might be the buzzing ...

...utility knife and split the hose, then peel it off the fitting. Jerking the hose around on the heater core end is not a good idea. Usually the hose will form around that fitting, use a utility knife, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...