Questions & Answers for: Makita utility knife

I have a Makita 6935 FDWDE. I need to separate the two halves for repairs but I can't figure out how. I have all current drawings but it doesn't really show anything. Any help would be appreciated. ...

carbon brush sparking and cause no power for electric motor when the switch turn on there is spark coming from the carbon brush of the motor and sometimes it produces smoke and also the electric motor

I HAVE SHARPENED THE KNIFE BLADES HOW DO I SET THEM IN THE PLANNER Planer blades can only go in one way, the set plate must go into the groove on the blade. If you sharpened them by hand, or even with

how to get the head off the makita Ml140 14.4 volt flashlight? I need to open the light to check wiring problem. I'll assume it is the same as my similar 18v makita. There would be spring loaded posts

how to remove case head from makita BML185W flashlight Flashlight goes out after being on for a minute or so. This started about a month after buying flashlight. Had pcb board and switch replaced ...

...utility knife and change the blade, you will want a brand new sharp blade for this. Start by cutting as much of the exposed towel off as you can. Remember, at this point the only thing you might be ...

...over. The proper tools would be either a router with an edge bit ( what I and most cabinet makers use ) or a low tech utility knife (carpet knife ) yep just a razor knife - really it works. ...