Questions & Answers for: Chevrolet utility knife

...insulation under your carpet gets in the way I usually carfully take a utility knife and cut out a small square to allow more room to pull it down and out ,depending on the placement of the

...cup. Cut out the blower motor using a utility knife in the narrow groove of the lower case. Remove the blower motor. Remove the blower motor nuts. Remove the blower motor from the blower motor

...knife or a utility knife and then remove the old heater core and install the new one then put everything back and dont forget to reseal the box otherwise you wont get much heat flow from the core de ...

...shroud will knock a ton of time off in installation and re-installation. I just scored the plastic with a utility knife, then used dykes, popped right out in perfect size with one cut with the

...utility knife to cut through the cover on the cut line as neatly as possible because the access cover has to be reinstalled. Starting with upper half of the cover, tear the remaining part of the ...

...shroud will knock a ton of time off in installation and re-installation. I just scored the plastic with a utility knife, then used dykes, popped right out in perfect size with one cut with the

...shroud will knock a ton of time off in installation and re-installation. I just scored the plastic with a utility knife, then used dykes, popped right out in perfect size with one cut with the

...remove and replace the cover. I am going to try and glue or silicone it back on. I used a utility knife. It was tedious to get the back side, but eventually it came loose. Take your time and be

...utility knife. Disconnect the cooling tube from the blower motor. Remove the blower motor mounting bolts. Remove the blower motor. To Install: Install the blower motor. Install the blower motor ...

...utility knife and split the hose, then peel it off the fitting. Jerking the hose around on the heater core end is not a good idea. Usually the hose will form around that fitting, use a utility knife, ...