...power steering pulley bracket sheared off. It was replaced. A week later the power steering pulley itself busted off. b) it was replaced. as was the water pump. Coolant is leaking one week later. ...
Question about 2000 Grand Cherokee
...Jeep Grand Cherokee with a 4.0 At least you have the 4 liter 6. Once you get all the **** out of the way its like replacing a W/P on an "old school" engine, very much like a Ford or Chevy straight 6. ...
Question about 1995 Grand Cherokee
...Jeep Grand Cherokee Laredo(not Limited)Power steering pump (AC - 6 cycl.). I wnet to the junk yard and got one off a '93 I believe. I got the old one off and ready to install (1)I am replacing a 1995 ...
...Jeep Liberty's belt is lose. I can fit a finger between the belt and the pulleys. It's a single belt system. This problem caused overheating, loss of steering power and battery drain (since all these ...
Question about 1995 Grand Cherokee
...power steering pressure hose (1995 Grand Cherokee) There is a visible hole in the pressure hose that squirts when the wheels turn. The hole is right on top of the hose (the fluid shoots staright up). ...
...jeep cherokee serpentine belt Hi look under the power steering pulley... you will find a nut there, LOOSEN IT ONLY! look at the back of the pump and LOOSEN the two bolts on the back. Then finally, on ...
...jeep cherokee the belt is adjusted pivoting the power steering pump assembly. loosen the top bolt on the PS bracket, the 2 bolts on the back of it, and the bolt holding the adjustment bolt tight (the ...
...power steering pump is it time consuming for beginer Pump is pretty much a take it out, put it in job. Use a flair nut wrench for pressure line fitting and if the new one comes without a pulley have ...
...power steering pump to it's bracket and use the transverse bolt under the pump to loosen it. If there is no diagram of the belt routing on the radiator support, draw one then remove and replace the ...
Question about 1989 Cherokee
...power steering is missing do not spray any lubricant or cleaner on belts. they are rubber made.you can use a dry soap if you can remove belt.on 4.0 engines it can be tightened a bit. there is a bolt ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions