Question about 3 gal. Air Compressor, 1.5 hp, Horizontal k
compressor fly wheel not hung up unit starts operation soon fly wheel starts to slow down like it is laboring then stops and motor overloads and trips protection switch It sounds like the unloader ...
2.5hp 40ltr unloader prob? i have a 2.5 40L project air compressor and every now and then it just stops and hums and so i turn it off and when the unloader valve relessers i turn it on and it goes ...
Question about 3 gal. Air Compressor, 1.5 hp, Horizontal k
My compressor builds to 125 psi then shuts off like it should then when the pressure is released the compressor wont start back up. Sometimes it will attempt to start and it sounds like the motor is ...
Question about 33 gal Air Compressor 6 hp Horizontal k Oil Free Pump
I have a Craftsman compressor Model # 919-15292 2. The compressor stopped building pressure because air was continually being released through the unloader valve. I have replaced the unloader valve, ...
If the compressor is empty it fills up with air just fine. Once it begins to drop in pressure (after being used) the motor clicks on and it putters and sounds as if it is barely running(clanking). I ...
Question about 2500 PSI Briggs & Stratton Powered Pressure Washer
do the spring end caps inside the 315747GS unloader valve face the spring or the ends of the valve need a diagram of the unloader valve to see correct spring cap direction This parts diagram for the ...
Question about 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer
How to adjust the unloader valve. what is the proper way to adjust the unloader valve? Is there a factory setting? With a pressure gauge. If it's a home duty model it can usually be turned all the way
Question about 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer
My Craftsman 919.166600 compressor takes forever to fill, what would be the issues Could be piston O rings, worn cylinder line, worn reed valve-plate assembly, worn discharge check valve, leaking ...
Question about 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer
My craftsman pressure washer 2.3 gpm engine slows down when turning on the pressure washer nozzle. What is the problem? When the engine is running but the high pressure lance valve is closed the ...
Question about 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer
...it works fine until it restarts. pressure relief valve is bad motor and caps are bad Either the unloader valve on the pressure switch is bad or the extension cord is too long or the start ...
Usually answered in minutes!
49 Questions
42 Questions
38 Questions