Questions & Answers for: Omega unit turn wont blow air

...turn the thermostat on and off in order to get heat. i have the thermostat to 70 and the heater will blow hot air and then roomtemp-air, therefore bringing down the temperature again. it's been two ...

...turn the unit on. It blows heat for about 3 minutes then it turns to cold air and wont shut off, until I shut it off. sounds like your drain is stop up in wich is filling your air swich up with water ...

no heat through vents I live in a condo, my heat turns on and blows hot air out around the furnance but no hot air is forced through the vents in any of the other rooms. So the condo gets heated ...

...air conditioner out side and inside unit is working or was till i shorted it out but i can fix that what my problem is it want cool when all units are on and yes it has freon When you shorted it you ...

...run, your compressor has an issue. If nothing runs outside, then your transformer on the inside unit(air handler) has an issue. This could also be a control relay on the condenser or the air

...to be a white-rodgers control panel inside. the problem is that the blower/fan doesn't always stop once the heating/burner stops and so the furnace continues to blow cold air. dodgy relay ...

...air conditioning mode, you can hear the furnace going on but the blower does not kick on. You can turn the fan on, but no heat comes from registers. If you can get it to turn on once, usually you ...

furnace won't stay lit Are your air filters relatively new? Is a bird nesting in your units combustion air exhaust pipe? Does your draft inducer motor run before and after the gas has ignited? ...

...turn on heat and still blows the fuse. Does not appear to be external to the AC unit or thermostat. Having difficulty reading schematic as it is very old, Does the 24V feed the sensors on the furnace ...

...wont turn on. Ive watched videos of how to assemble it and I think its assembled right. I made sure the electrical outlet was working. Any Ideas why it wont turn on? Could have had motor failure from ...