...programmed but it sounds like the squelch is to high all the time Uniden wont admit it but it has installed faulty squelch on the 248's I had the same issue. Wont sell parts either. 60 bucks to
...squelch I have a uniden bearcat scanner model bc248ctl and im unable to shut the squelch off. It acts like it is stuck open and no matter which way you turn the squelch it wont shut off. This is an ...
...squelch is stuck uniden bc248clt acts like squelch is stuck, wont scan. when i push scan it goes to channel 21 and stays there I had the same problem. Your board may be fried. I had to buy a new
Uniden UH-013 squelch I have a Uniden UH-013 My complaint is the squelsh chatter on weaker signals. Is it possable to modify the decay time without altering the atack time of the squelsh. I haven't ...
...squelch pot is either shot or disconnected. If you're electronics handy, you can troubleshoot it yourself and replace the pot if necessary. You can also send the scanner to Uniden for repair. Follow ...
Question about BC248CLT Base Scanner
squelch ? Have Uniden Bearcat hand held scanning radi can't break squelch ? What's wrong ? Look at the squelch knob. If it is turned fully counterclockwise, it is in "Auto". Turn the knob clockwise to
uniden bc340crs scanner just static and will not run thru channels An unfiltered power supply my give that problem or you need an external arial Had the same problem with my scanner. The squelch ...
...channels,squelch will not work.Can how ever program for trunk tracking but can not receive anything Because the sqelch control is broken, you may have to send your scanner to Uniden for ...
Question about Bc350a Nascar Police Scanner No Antenna mods
Squelch is open all the time on uniden bc350a scanner Hi, Have you turned the squelch knob all the way in both directions, to see if that helps? If so, then you have to replace that squelch knob unit,
Question about Bc350a Nascar Police Scanner No Antenna mods
squelch on a uniden scanner model# bc142xL? & will scanner still work? model# bc142xL Why would you try to disconnect the squelch? If you turn it one way, it does not work at all. If you don't
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions