Questions & Answers for: Zanussi unbalanced washer stops during spin

...stops and the lights go off. New door sensor im afraid,unless the machine senses that the door is properly shut none of your wash or spin cycles will start.Sensor located inside washer casing , where ...

...washer seems to complete all of its cycles, but it doesn't spin: 1) Be sure the load of clothes is not lop-sided, and dont overload. If the tub becomes unbalanced, it may spin erratically or not at ...

...If you hear loud thumping/or sound during the spin, the load of clothes may have become unbalanced. Stop the washer and redistribute the clothes, then re-start it. Repeat these steps if

during the spin as it sounded as if it was 'taking off', when I took the clothes out they had spotted oil marks from the drum. bearings have failed. replacement is quite a hard job if you haven't done

...the washing cycle, drain but not spin. The clothes come out soaked any solutions is it spinning during spin cycle your timer may have gone the end light is flashing 11 times repeatedly what is the ...

during programmes Keeps stopping mid programmes - especially cotton wash (example stopped with 1hour 13 minutes left on a syn 60 cycle, now wont do anything). If I switch it off then back on sometimes

...stops during wash cycle and clothes not dry on drying cycle not familar with the code but usually wash has a built in thermo stop to wait for water to heat to correct temp,if it works normally in a ...

...washer then check these things if it is making noise-- Bellows The bellows is a rubber sleeve that seals the suspended outer tub to the stationary cabinet front at the tub opening. Its purpose is to ...

...stops there is water in the drum and you can open the door. Is this something i can fix or is my washer completly broken. Please help. If you can hear a rumbling sound from the drum, then I would say ...

...unbalanced. Try removing some items then set to spin again. Alternatively it could be that the water is not pumping out. Check the hose from the machine to the drain. Check the filter / junk catcher. ...