Questions & Answers for: Garmin what type of solder

...type of precision soldering work. CroceF- I just opened up a Garmin 60CSx and found that one of the contacts came un-soldered from the board. I placed the contact back on the board and heated gently ...

...is a break on the circuit board and you are pushing pressure to join the break, or there are other types of cold solder connections, or the volume control itself is defective. Jerry

...solder type battery of my GPS III Plus with a battery holder (clip) that a ?Basic CR or BR2032 Coin type battery?, without solder connections, that is, they simply clip into place. Replacement ...

...type do I need? 2. Where can I buy it? 3. Where is the battery located, how do I change it and how do I get inside the case? Pry it apart along the edge with an exacto. Be careful around the antenna ...

type) and solder in place. Reinstall the power and antenna connections in the cover, replace the cover, power up the unit and start re-creating all your lost waypoints. Batteries can be ordered online

...solder joints. It's caused by a defective part. We sent a "marked" defective unit to the repair shop mentioned above and upon its return, disamantled the GPS receiver assembly and made the following ...

...18003444539. part nos from DigiKey: P080;P080-ND;VL1220-1VC;VL1220-1VCE;VL1220/1VC;VL1220/1VCE. The type was 12.5mm 3v 7.0mAh price: $4.45 but not in ...

...is Low ) how to solve this The memory battery is a BTR2032 or a CR2032. This is one of those coin type batteries. To replace it you need to open the case and depending on when your unit was made

...type antenna to the antenna port on the back.  If the problem goes away, then the problem is definitely in the built in antenna.If you lay the GPS display side down with the flip up antenna to ...

...type antenna with an SMA connector and plug it into the back of the Quest. (2) If you feel comfortable soldering small circuit pieces, remove the flip up antenna by placing the quest face down on a ...