One of the rear disk handbrakes on my car is not gripping. Can anyone help? check the cables under the car. There is 3 of them.
...twist" or "strip" sockets. Most likely available at any tool/parts store. You tap them on the stripped lug nut with a hammer and the grip on the lug nut gets tighter as you loosen the nut. As long as ...
i have a 2004 mondeo hatch i opened the boot yesterday and now it wont closeiv tryed fuses but all ok you may have bent the actuall claw thing that grips it shut or it may have got jammed reply if ...
...difficulty removing the sensor still its stuck tight are there anymore retaining pins? do i need to twist sensor into a certain position to remove? pulls out but are very tight try warming the area ...
...Ford Focus Can't grip installed bulb base firmly enough to twist bayonet mount free. common problem,the base gets corroded to the fitting,once the glass has broken,use pliers to twist and pull
...making them more like tail lights now. You just take the center of the light bulb from the back and twist and pull. The little bulb should be looking at you nw. Then you can either push in and twist ...
...bulb from back of assembly without removing entire assembly The bulbs most likely are a three tab twist and turn replacment. Depress the clip at the back of the bulb for wring harness and pull ...
...the retaining clip of a 2004 ford focus zx3 to replace the headlight bulbs? They are sort of like a twist out type of thing...they should onlt twist about 1/8 to 1/4 of a turn and then pops ...
...How is the piston compressed or retracted? Hi There. you may have to turn the piston back in (ie;twist ) some fords have a sort of threaded self adjuster, so you will need a large pair of vice ...
2001Ford Focus hood release cable I want to replace the hood release cable Remove the handle inside the cap. Your goal is to get 2-3 inches of cable so you can use a vise-grip to pull open your hood.
Usually answered in minutes!
3,749 Questions
2,612 Questions
2,055 Questions
1,226 Questions
897 Questions