Questions & Answers for: Yamaha twist grip

...and spray WD-40 down the cables. Cable adjustment should leave 1/16" play (worst case) when handlebars are turned full right or left. Also clean where twist grip rides on handlebar. Goodluck ...

twist the throttle rapidly and listen for the carb slide to move up and down,, ya should hear a clicking in the carb... if so slide ok.. Sure bout the throttle cable ? At grip ? When starting the bike

...twist the throttle grip and let it go. It should snap back with no hesitation or delay. If it seems sticky, try cleaning and lightly lubricating the grip, cable and carbs. Disconnect the cable from ...

...tube turns on the handlebar, or the rubber grip touches the throttle assembly, assuming the cables are not frayed. they fray usually at either end, inside the twist grip or at the carby ...

...try try turning the choke on,which is on the left handle bar next to the grip,leave on ,twist throttle full then close it,press start button,should start,let run for a few mins then turn choke

twist grip turns freely on the handle bar. Check the new grip doesnt push against the throttle switch assembly. Check the cables move freely Check the cables dont have any frayed ends check the cables

...hand grips Take off the bar end weights. Peel off and save or cut off old grips. Put glue on the twist throttle pipe and metal bar and slide on new grips. Reinstall bar end

...twist grip assembly, an abused outside end of the twist grip and the twist grip assembly forced too deeply into the handlebar. Lube the cables with graphite lubricant only. Lock Eze is a brand name ...

...make sure that the cable is not frayed anywhere that could make it stick. Also make sure the cable is lubed up good and slides freely. make sure that your twist grip on the bars is working good

...grip, I can twist is back down to an idle, how do I adjust this beast? Try lubing your cables and throttle mechanism first. Do your adjustment when the bike is warm. It sounds like you're making ...