Questions & Answers for: kawasaki twist grip

...twist grip by pulling it off the bar with the swtich grear then remove the nipples from the twist grip then remove the cables from the switch gear then refit in reverse and adust the cables should ...

my throttle round it clicks at the half way point also it wont always return on its own Sounds as if the inner cable is starting to fray and catching in the twist grip. If so cable will need replacing

...twist grip, they run a second cable that closes the throttle. You can get to the cables with some pointy pliers etc, but dissassemble the twist throttle first If you must remove carbs, loosen all the ...

hand side plasic piece N GRIPP????? All ZXR400s use the same throttle cables I'm not sure about the twist grips but any should fit Ride safe Bike-Doc Please mark this as very helpful (if it has been!!

bike stood for 5mth throttle twist grip will not rotae Remove cables from carbs and check for free movement. Carb butterflies may be stuck.

...you need to regulate it, either by the bolts down to the gear box, or up at your left grip by the twisting distance screw. The best way to do it right, is FIRST, spray down to your cable enough ...

...in the baffle, some have an 8mm Bolt or alun head bolt, remove the retainer and grip baffle twist an pull slightly to remove some baffles have silicone around them to seal it which could hamper ...

...twist grip side header pipe glows red on tickover checked carb for fuel blockage and air leaks none found but the fuel tap will only work in the pri position so is this my problem check the vaccuum ...

twist grip. The new cable is the one with the bent tube at the twist-grip end. Any help will be appreciated You have not listed your model. Generally, remove two or three screws holding the right hand

...twist and give gas I lubricated the the cab?Ex after taking g it apart at grips but no prevail can anyone help me with this problem? When you disconnect the throttle cable from the hand grip control ...