Questions & Answers for: Harley Davidson twist grip

...twist the throttle one way then the other to dis connect cables( there is 2). Old grip should slip right off. Is ther manual cruise on it? If so, that will need to be dis assembled as well (in the ...

...twist grip and remove it. Lubricate the new throttle sleeve with white lithium grease and slide in onto the handlebars. Reinstall the throttle and idle cables with their ferrells in the appropiate ...

twist the throttle to wide open throttle and let go of the throttle grip. The throttle should snap shut. If not, loosen the cables a bit or back the throttle grip a bit further off the handlebars. The

...twist grip. Adjust the adjuster barrel inwards all the way getting as much slack as possible. Now, loosen the bolts holding the front master cylinder onto the handlebars and slide it towards the ...

...twist the throttle grip two times and let go), turn on ignition switch, push starter button. Leave the throttle completely closed while cranking. Allow engine to warm up just enough to turn the ...

TWIST GRIP SENSOR 4.10 REMOVAL Remove the left side saddlebag, remove the left side cover, remove the main fuse, (Do not remove the switch housing assembly without first placing the 5/32 inch (4.0 mm)

...twist grip sensor) these faults come up intermitantly, any suggestions? Hi Anonymous, try clearing them, for more information about your question please visit the website below. Good luck and have ...

...cable adjuster in. Remove top half of throttle grip housing and remove cables from sleeve. With a twisting rocking motion on throttle cable pull it out of lower housing. If it won't come out you

Electronic throttle not working fro street glide Likely the twist grip sensor but WHAT DTC 's are set?

...twist grip. At the carburetor, I always start with the return cable that has the spring first, insert the cable end ferrule into the throttle shaft wheel and then the spring into the cable guide, ...