Question about MLT3221 32 in. LCD TV
tv it said it menu because the Verizon cable box was in standby mode I hit menu and now it says no signal and i can not find a code ofr my RM-YD010 sony tv remote to get the signal back. are you using
...Standby Red Light does not come on when you plug in the TV: 1) Check fuse on back panel next to power cord. Pull out cord and pop fuse holder out. On an ohmmeter, it should read 0(short)-that is a ...
...TV went in standby and does not wake up, then the TV is in protect mode. In protect mode higher voltages from PSU gets shut down and TV remains in standby.(see also Why my TV does not start up and ...
...tv yourself be careful for voltages. Check the power board for standby +5 volt to the power botton. If there is none, check the powerboard for open contacts; fuses, fried resitors or the FET. A ...
standby button, blue screen appears then shuts off within seconds. More likely to have bad backlight inverter board, post picture if you can, you can check the fuse on it to see if it is OK. Failed TV
...standby light turn green. The unit checks to see if a dvd is the player and then cycles the dvd player since not disk is present and does not proceed to turn on the tv portion of the unit. Hello, The ...
Question about MVUC821 8 in. Under Cabinet TV
tv does not come on, picture or sound. When the power button is pressed, the unit goes from standby mode (red light on) to on (red light off and blue light on) and the built in dvd drive makes a sound
...TV power supplies its only standby circuit produces 24V and those can be measured at any time - on or off - at connector CN3, where the first three pins are ground, the second three are +24V and the ...
Question about MLTD2622 26 in. LCD TV
...standby runs 7/24 and the heat dries out the caps and they fail. 3. Trouble shooting consists of the above and then at some point you have to buy and try a board to see if it fixes it or not. 4. ...
Question about MLTD2622 26 in. LCD TV
my memorex mltd2622 wont get power the standby light wont even light up please help Check its main power regulator board for fault. Check and replace it as card basis.
Usually answered in minutes!
157 Questions
132 Questions
83 Questions
45 Questions
51 Questions