Turntable speed The turntable will only play at 45rpm. The speed button seems to function correctly but regardless of the position I can only get the 45rpm speed. most of these were belt driven, if ...
uneven speeds I am getting uneven speeds - speeds up then slows down at unpredictable times. Could it be the belt? belt came loose please help[
...Turntable Platen speed This is a virtually new Sony PS-LX250H belt drive turntable. The drive shaft turns and the belt seems to be just about brand new and perfect but the platen doesn't turn at the ...
...speed on this turntable. I timed it with a stopwatch and it's playing my LP's exactly 1 second too fast than the CD version of the same LP. Thanks. Without technical equipment it would be near ...
...turntable is playing records too fast. how do i fix this? there are two small holes under the unit labeled 33 and 45 that control speed. im guessing youre mainly playing lps so use a flathead jewlers ...
Question about PS-LX250H Turntable
...speed of the turntable. It only turns at 45 RPM (switch open.) It's likely the belt has come off the correct position. It would need to be adjusted. One reason it's moved is that it needs replacing, ...
Question about Ps-lx50 / Ps-lx50p Stereo Turntable System Service Repair Manual
turntable speed is too slow. Do I need a new belt? The records were playing and Iwent to put on another record and the speed was too slow. When I put the arm over to begin playing the turntable didn't
Question about PS-LX250H Turntable
...speed controls might be underneath the turntable base. Sometimes covered up with white stickers. On other models you have to remove the bottom side to get access to the PC board, where the controls ...
Question about PS-LX250H Turntable
...speed of a Sony LX250H turntable? The answer is not in my manual. Presumably you mean correcting the speed to play 45 and 33 correctly? Some turntables have the speed control(s) as a preset(s) built ...
Question about PS-LX250H Turntable
speed of your turntable is governed by an electronic circuit and this is where the trouble is. The cost of a repair is going to be mostly labor which may exceed the value of the value of the turntable
Usually answered in minutes!
415 Questions
267 Questions
266 Questions
180 Questions
148 Questions