Question about NN-T993SF Microwave Oven
turntable is turning but it's not heating anything Sounds like the magnatron (the bit that creates microwaves) could be goosed. Remove outer cover ( Isolate from the electric supply then remove screws
...turntable & light worked - then after 30 seconds it just turned off. The : was still on. Light comes on when I opened the door. I unplugged it for 1 minute to reset any internal but still it does ...
...shop. If you feel confident, disconnect it from the mains power, remove anything in the cavity and turn it upside down if it is a tabletop model, a little more complicated if it is built in! Remove ...
...shop. If you feel confident, disconnect it from the mains power, remove anything in the cavity and turn it upside down if it is a tabletop model, a little more complicated if it is built in! Remove ...
...shop. If you feel confident, disconnect it from the mains power, remove anything in the cavity and turn it upside down if it is a tabletop model, a little more complicated if it is built in! Remove ...
turntable has stopped revolving Unfortunately unless your are under warranty there is not much you can do. The table is driven with plastic gears and these wear or break. You can call a repair shop ...
Question about Technics SL-1210MK2 Turntable
turntable require a pre-amp or something? If the unspecified Sony has a "PHONO" input you should be good to go. What model? "PHONO" is the only designated connection on an audio device that is literal
...shop/panasonic-microwave-glass-turntable-plate-tray-f06014m00ap-p-156.html And here is another link to that part from Sears Parts Direct: ...
Question about Technics Sl-1210 Mk2 Turntable black Sl1200 Proaudiostar
...turntable but when trying to play a vinyl the power cuts out, resulting in having to replace the F1 (250mA) fuse. Any suggestions? ability to switch between 110 and 220 voltages. is it set at ...
Question about Technics Sl-1210 Mk2 Turntable black Sl1200 Proaudiostar
Having a difficult time removing the horseshoe clip.Help with this. It's possible you don't have the right tool for the job. Small radio pliers are best. You can get them from your local repair shop ...
Usually answered in minutes!
80 Questions
95 Questions
80 Questions
69 Questions
56 Questions