...turntable platter is a common problem. There could also be a problem with the spindle motor driver controller IC or the power supply regulator that supplies voltage to the driver IC. If the disc ...
My PX-E860 turns on, but will not spin. Just needs a new belt. You can get those at audio shops. Just take the table off and take a look at the belt size (should say) or take the belt to an audio shop
Question about PX-E860 Turntable
Aiwa AP-2600 Direct Drive Turntable - platter not rotating Aiwa AP-2600 Direct Drive Turntable. Purchased new in 1982, this turntable has been fine until recently when it needed a push start to get it
HOW DO I REPLACE NEEDLE Hi there You replace the needle on this turn table as a complete item. The plastic assembly that clips to the tone arm carries the needle. You can get one here(click, picture ...
How do I rethread the belt on my PX-E850u Turntalbe? Hello The turntable bests cannot be rethreaded. It should be replaced with same size. Just go with the broken or loosen belt to any electronic ...
TURNTABLE THE BELT THAT MOVES THE ARM TO THE RECORD IS BROKEN. WHERE CAN I BUY ANOTHER ONE, AND IS IT EASY TO FIT Hi jun_tradjazz, I have an LX 70. There are two drive belts. They are identical and of
Question about PX-E860 Turntable
...shop.Good luck,Alex. I believe this is a belt driven turntable. With the power off, carefully remove the rubber mat. Turn the platter by had until you see the motor pulley through the open holes. If ...
...turntable squeaks? Clean dust out. Get some Silicone Grease and use that on moving parts. Use a straw in your ear to locate the source of the noise. Silicone Grease can be found at Maplin (in the UK) ...
Usually answered in minutes!
110 Questions
49 Questions
43 Questions
33 Questions
30 Questions