Questions & Answers for: Xerox Phaser turns on and off

Error timeout Timeout error prints on each page of printout There is a firmware update for the Phaser 8500 that fixed this for me. the imaging drum timing alignment sounds like it is off...try ...

off when the phaser is turned on the light for the scanner/copier turns on and stays on despite the fact that the lid is closed. How can i turn this off? i dont' want the bulb to burn out. Thats not a

The print always prints one page when I turn it on The xerox phaser 6200 always prints one page when I turn on the power. Could you teach me how to turn off this function. You have to go into the menu

7,010.43:40975 error message for the Xerox Phaser 8500 printer. The printhead is stuck in the tilted position. Did you have a power outage or turn it off by unpuging it? Not hard to fix but you have ...

Xerox Phase 7400DN - Getting a 941 Fault code, what is it and can I fix? I turned it off and back on and the 941 showed up again. Turned it off and back on and for now its ok. 941 CM Toner Supply ...

Printer error. Turn off the printer, and then turn it back on again after a moment. If the same error occurs, turn off the printer, then contact the store you purchased the printer, or a service ...

fault code 004-350 marking device failure i turned power off for a minute and back on but same problem exists Sorry, Phasers need more than one minute to reset. You need to turn off and unplug the ...

...a red light when i switch it off an leave it off 10 minutes , the turn it on it turns on the light becomes green the it tries to warm up and then turns red again you should replace toner ...

error code e1 showing at xerox pro 420? solution.. model no.420 rror codes If the printer's front panel displays a message Error XX, find the error code in this table and follow the instructions for ...

Phaser 8550 is showing paper jam in tray 2. No jam. Message won't clear. I've removed all trays, opened front of machine, restarted it, turned it off and unplugged then plugged in and turned back on. ...