Questions & Answers for: Volkswagen Beetle turn single

Question about 1999 Beetle

1 Answer

...turn over. There is a single click and can hear the fuel pump come on and still nothing. Am searching what could be wrong. Before this I rinsed the engine down with water due to the recent coolant ...

Ad

Question about 2000 Beetle

2 Answers

...single negative lead wire running to some sort of switch in the seat belt locking mechanism. When the male end of the belt is placed into the female lock the switch will be depressed and grounded to ...

Ad

Question about 2001 Beetle

2 Answers

...single time i do it and i changed my oil by my self so how do i get it to turn off is there a fuse or something i can disconnect to make it stop or should i take it in and get it repaired and if i do ...

...turn single relay it fairly cheap to replace. next if that don't work, you going to have to wait when the problems occur again by going around by removing the lense cover one at a time; wiggle thee ...

...turn on the ac from inside the car. The front of the pulley(clutch) will spin when turned on. If it does not spin, the low pressure switch (LPS) is not satisfied. Meaning there is not enough freon in ...

...turn knobs in the dash. Left is for temperature control, center is fan control, and right is vent selection. The center button on this years model is famous for shorting out causing the fan to not ...

Question about 1999 Beetle

1 Answer

...not and I didn't get installation instructions with the new single mass flywheel clutch kit. vw says to tighten the original dual mass flywheel bolts to 44 ft lbs and then another 90 degrees of

73 super bettle, turn singles light up but don't 73 super bettle, turn singles light up but don't blink. Same with hazards. Is it the flasher? The Flasher is located: - Hazard flasher: Front ...

...SINGLE ELEMENT FUSE, MAKE SURE IS GOOD OR REPLACE IT, LET ME KNOW. Try the FAN part of this: If your engine is overheating, Try this procedure: Dirt and debris can get lodged in the radiator air flow ...

...the MAF sensor, engine speed sensor, replaced the factory airbox with a K&N, kept stalling. Turns out the problem was something that not a single mechanic thought of, and that no diagnostic ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...