Questions & Answers for: Chevrolet 3500 turn single

1995 chevy truck 3500 single axle trans will not stay in overdrive it is always searching and will end up in 2sec gear Any codes??

...turn single drivers side don't work Have put in a new tail light, the brake and turn single don't work. The 4 way flasher works and if you hit the brake while they are on the brake light works. Turn ...

...Brakes - 2 Brown = Tail and clearance lights - 3 Black = Battery, aux power - 4 Yellow = Left turn/Brake - 5 Green = Right turn Brake - 6 Orange or Purple (not both) = Auxilliary or Reverse - 7 ...

where is the hazzard fuse located on a 2007 chevy 3500 Durmax? I have no turn singles or flassers. [email protected] all of those fuses should be located in the underhood fuse block on the drivers wheel ...

When I turn the ignition key all I hhear is a "clunk" at the starter. The starter has been replaced, the battery has 13.6 volts and the engine turns freely by hand. If this was doing this before you ...

where is the sending unit located for the temp gauge on a 79 k5 Blazer? Hello My name is David, I'll be assiting you today: You will find your temputure Swith on Top of your Enging on your Thermastat ...

...single programming sequence. When using this program method, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter. The order in ...

i have a 1997 3500 the right turn signal keeps popping the turn signal fuse already replaced turn signal switch what else do I try I would look for a short to ground in the sockets and the harness.

serpentine belt A serpentine belt (also known as a multi-vee or multi-rib belt) is a single, continuous belt used to drive multiple peripheral devices in an automotive. if you need a diagnostic ...

...when brake pedals pushed When I push the brake pedal the reverse lights come on and then when you turn the turn signals on the reverse lights blink, also my hazard light button broke off, do I just ...