reset ANTI-THEFT DEVICE FOR OLDSMOBILE ALERO Three cycles of ON-OFF: Turn ignition ON, wait for 10 minutes. Turn ignition OFF Turn ignition ON, wait for 10 minutes. Turn ignition OFF Turn ignition ON,
steering wheel is locked. can't turn key Try rocking the steering wheel slightly (it should turn just a little bit) while gently trying to turn the key. Sometimes if you turn the ignition off (to the ...
i was tryna figure out what could be the problem if my wheel is getting hard to turn when backing up and certain turns and the power steering fluid is full??? The power steering pump is getting weak. ...
cruise control kicks off when left turn signal is used. Right brake light goes out when left turn signal is activated. ABS light comes on when left turn signal is activated twice. this is a 1995 Olds ...
what does a fuel cutoff relay do it cuts the fuel off. FUEL PUMP RELAY TURN ON AND OFF THE FUEL PUMP.WHEN YOU FIRST CRANK YOUR ENGINE PCM ENERGIZE FUEL PUMP RELAY TURN ON FUEL PUMP.IF ENGINE DONT GET ...
Question about 2000 Alero
After using turn signal you can still hear clinking, is hazard relay part of turn signal The hazard switch is also the device that supplies the turn signal "flash". If you continue to hear the noise ...
Question about 1997 Cutlass Supreme
turn lights blink with hazards but not with turn signal..flasher replaced. is It the multifunction lever then?? There should be a turn signal flasher and a hazard flasher. They are two different parts
no turning signals Turn Signal Lamps The turn signal lamps are made up of the front park/turn signal lamps and rear turn signal lamps. The front turn signal lamps flash with the rear turn signal lamps
Question about 2001 Intrigue
The turn signals don't work on a 99 Oldsmobile cutlass and the fuse isn't blown how can I fix When the ignition switch is in the RUN or the START position, voltage is applied through the TURN/LPS fuse
Question about 2001 Intrigue
...Check it by using your hazard lights. If they flash, the relay is OK and you have a woring issue. Turn Lamps With the ignition switch in the RUN position, battery positive voltage (B+) is supplied ...
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
988 Questions