turbo on an old mini copper How do I get a turbo on a mini cooper 1275 from il think 1975 there is a posibility on the motor only I can't find any documentation nel saman you cant put a turbo on,it ...
...turbo tends to boil the oil in them and coke the lines. Let them run for about a minute or two before shutting down so the water cooling can bring down the temperature. Oil is cheap compared to turbo ...
...turbo locking up due to coking in the oil feed supply line. Clean oil is a must in these mini's. there's a good possibility that the engine or parts of it are running to hot, check the entire cooling ...
Question about 2005 Cooper S
...are doing it... check the prices of the units below (two engines listed... I only posted one (non-turbo) ...
...leaking something onto my driveway. It feels like oil and is clear. Should I refill this reservoir? It says only CHF 11S on the cap. refilling is a good idea-but you need to find where its leaking ...
2007 (hatch or clubman)??? no country told. nor any VIN# told, gee BMW demands a VIN for parts. got turbo.? Hatch list. 1.4 L Prince I4 (One) 1.6 L Prince/BMW I4 (Cooper) 1.6 L Prince turbo I4 (Cooper
Question about 2008 Cooper S
...oil? Does turbo need oil? Very much so. It has parts spinning at 30,000 rpms or so, and the bearings require oil to live. Clean cool engine thoroughly, and then run engine to find leak. Turbo uses ...
...leaking oil supply line and started the engine to test within few minutes notices smoke and than oil poured underneath. Could it be the other end of the oil supply line gave up? Bummer out. Two days ...
Question about 2012 Cooper Clubman John Cooper Works 2dr Hatchback 1.6L 4-cyl. Turbo 6-speed Manual
my friends mini clubman 2009 running jerky would welcome any ideas please Tune up would be the first place I would look into. All filters as well, air, oil, fuel. I agree another question is was it ...
Question about 2012 Cooper Clubman John Cooper Works 2dr Hatchback 1.6L 4-cyl. Turbo 6-speed Manual
oil change found out at had a leaking valve cover gasket and the oil pan soo fixed them... now when I start it.. It starts good drives good but when I get to a stop it misses and dies can't figure out
Usually answered in minutes!
384 Questions
294 Questions
275 Questions
253 Questions
183 Questions