Questions & Answers for: Nissan Altima turbine shaft speed sensor

Question about 2002 Altima

3 Answers

...shaft sensor. I have replaced the crank shaft sensor but the car is still not fixed. It stalls at low speeds but still can be dangerous. What am I supposed to do? could be cam sensor fault or just ...

Ad

...speed sensor is located in close proximity to the crankshaft. In addition the EMS uses minute variations in the CKP sensor data to determine engine misfire. The EMS uses this information in ...

Ad

...as measured by the input and output shaft speed sensors. if i have code p0734 and this means the trans is slipping what part can ni buy to fix the problem or do i have to replace the

Question about 2006 Altima

1 Answer

...po725 code its engine speed fault ,replace crank sensor.for vehicle speed there are two identical sensors near each other on trans....one called revolution sensor other is called turbine speed

Question about 2006 Altima

1 Answer

...i replaced cam and crank shaft sensor just to find out it was the fusible link on the battery. Cant find them at the auto parts. I had to get mine from the reckyard  or at the dealer or

Question about 2005 Altima

1 Answer

...TURBINE SHAFT SPEED SPEED SENSOR NO SIGNAL. CODE PO722 OUTPUT SHAFT SPEED SENSOR NO SIGNAL. CODE PO500 VECHICLE SPEED SENSOR CIRCUIT MALFUNCTION. SOUND LIKE YOU HAVE TCM ECM PROBLEMS GETTING TOO MANY ...

Question about 2005 Altima

1 Answer

...speed and it might do it again in 30 min. or aweek later. we replaced the cam shaft censor & crank shaft sensor. now it continuely surges mildly and the tacometer jumps. the check engine light is ...

Speed Sensor (Turbine Revolution Sensor)Check in THIS LINK testing and description.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if

...15 min, cars operates well until the next time...had turbine sensor changed...ses light is on again also Time for a transaxle rebuild You drove it knowing you had problems & ruined it ...

shaft sensor and just replaced the engine speed sensor those were the codes that showed up on the diagnostic meter at advance auto If you are using more gas than usual I would be checking the air mass

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

2001 Nissan Altima
2001 Nissan Altima

569 Questions

1995 Nissan Altima
1995 Nissan Altima

534 Questions

Manuals & User Guides

Loading...