Questions & Answers for: Lexus GS 300 turbine shaft speed sensor

...came on, what happen did I trigger a sensor or something when I replaced such parts, i just dont get it. i hooked code reader 2 mine and it says cheak wheel speed sensor but i have not replacd it ...

Ad

Question about 2001 Gs 300

2 Answers

...off the transmission and check/replace the input shaft turbine speed sensor. Hi, I have P0715 error for my Lexus LS430. Changed for the speed sensor and also socket .. Error still come back. Any

Ad

Question about 1998 Gs 300

1 Answer

...speed sensor (there are 4) or the module that controls the system can be defective, since the cheapest part in the system is about $150 this test for fault codes is vital to a fix that doesn't put u ...

...ON A 2001 LEXUS GS300 WHAT IS CODE P0715 ON A 2001 LEXUS GS300 P0715 Input/Turbine Speed Sensor Circuit Malfunction It seems that you may have a problem with your sensor on or in your

Question about 1995 GS 300

1 Answer

...the speed sensor on the transmission for loose wires or broken wires ,also in the fuse box one fuse controls the speedometer ,rpm .well the check engine light .usually that's the 20 amp fuse

Question about 1995 GS 300

1 Answer

changed the relays but that too proved to be useless Have him/her check his his work!! The Wheel speed sensor may have been damaged/diconnected or has become loose or dirty when the work was performed

...speed sensor was back on the right side. After I got the car back the car wouldn't come to a complete stop without pushing the car another 100 feet. I took the car back and now there saying ...

...apart to find out if it is in fact the speed sensor. Any recommendations or suggestions as to what it may be? Could be speed sensor why take apart just change sensor,car is 12 years old and

Traction control lighting while the car is running if the light comes on during normal driving not wet or icy out then you need to check your wheel sensors the low traction light indicates the wheels ...

...turbine speed sensor A. P0715 is detected when TCM or ECM does not receive the proper signal from the sensor. Take a look at any damage to the loom wiring, including connectors before replacing the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...