Questions & Answers for: Hyundai XG300 turbine shaft speed sensor

...output speed sensor. This might also be the cause of sending wrong info to the computer. Another one might be the O2 sensor thought i think this might be unlikely. I hope this was helpful. Good

Turbine Speed Sensor Circuit (transmission related) P0115 Engine Coolant Temperature Circuit (fuel/air mixture related) P1191 is a manufacturer-specific code related to fuel/air mixtures, as is P1193

Speed Sensor Failed My Speed sensor is bad. I would like to save some money and change it myself if possible. Where is the speed sensor located? And is it accessible? I had the same problem, I first ...

...light on, showing the following codes. P0715 Inpuet/Turbine Speed Sensor Circuit and P1159 Variable Intake Motor Fault What's my problem? clean up all ground wires but you may need both of those ...

...speed sensors on the transmission. Simple exterior sensor replacement. Good luck sounds like real low on transmition fluid and you need to replace trany filter always start with cheapest and ...

...on, car stalling and rpms dropping when tcs is off. Codes are p0134 and p0717. what could be the problem p0134 is oxygen sensor fault code p0717 is turbine shaft speed sensor (no signal) fault ...

speed sensor where is it located? Hi The speed sensor is on the transmission. It is under the air cleaner box. The input and output sensors are located there too. They are attached by one bolt each ...

...sensor is watching shaft movement, but no movement seen.... $500 for intake plenum alone.. (IMG:http://www.hmaservice.com/data/Passenger/HY/HMA/ENG/DTC-Images/HY-XG13-IMAGES-ENG/xg35dp201511.gif) ...

...speed sensor a few months ago it was doing the same thing only it did it at about 30 mph and the check engine light came on after a few weeks before i changed the sensor, could it be the other sensor ...

2001 Hyundai xg300...P1632 have replaced the input and output sensors and one of the abs wheel speed sensors. Trans is starting in 2nd gear... limp mode P1632 is for the transmission computer. The ...