Questions & Answers for: Dodge Intrepid turbine shaft speed sensor

...turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info ...

...issues I've seen have been with the "Input" and "Output" Turbine Speed Sensors. They are both mounted on the trans case (External). The input is towards the front and the output is near the

Ratio Incorrect. I purchasec a speed censor already. You are on the right track. Replace the output shaft speed sensor. It is on the drivers side of the transmission closest to the rear of the vehicle

...cleared codes shifted once and would not shift again states gear 2 incorrect ratio gear 1 incorrect ratio Check the input shaft and output shaft speed sensors on the transmission. One is likely

...bouncing all over the place as well, It likes Second gear, Have the feeling its the speed sensor on the trany, anyone have any ideas? If the speedo is goofy it is likely the output shaft speed

...shaft speed sensor. This controls the signal for the speedometer and the shifting. Check the output speed sensor. It is VERY common for these to go out. You will likely have a service engine soon ...

...speed sensors on a 1999 Chrysler Intrepid Both the input sensor and output sensors are located on the left side of the trans axle case below the shift lever and above the stub shaft.Both should ...

turbine input shaft speed sensor circuit where is it located both input and output speed sensor are located on the left side of the transaxle case. do not interchange input and the output sensor.

...but the car wont shift. Any suggestions? Check for codes, may have a bad speed sensor either input(turbine) or output (vehicle) speed sensor. They are a common problem with the Chrysler

how to change a speed censor on a 2004 intrepid need details how to change a speed censor Wheel speed or trans turbine speed sensor?