Questions & Answers for: Dodge turbine shaft speed sensor

...it. Thankyou for your time and help. You need to have a shop scan the TCM for codes. Then you can determine what is wrong. These are good for having bad turbine shaft and output shaft speed

shaft speed. The intent of this diagnostic is to detect if the transmission is slipping or an invalid gear ratio is present. When Monitored: Engine RPM greater than 450 RPM , output speed greater than

...turbine speed sensor and the shaft speed sensor on a 2001 Stratus R/T Coupe? look on the tranny,especially near where either axle enters the transmission. most likely they will have a 2 wire plug ...

...Turbine Speed Sensor and the Output Shaft Speed Sensor. The cost to replace either of the Speed Sensors is estimated at $25.60 for parts and $32.50 for labor. All prices are estimates based on $65.00 ...

...turbine speed sensor? I have the R/T v6 3.0L Coupe MAKE SURE YOU IGNITION KEY OFF POSITION. YOUR VECHICLE SPEED SENSOR IS LOCATED IN THE INPUT SHAFT HOUSING NEXT TO TWO FLUID COOLING LINES TO REMOVE ...

turbine input shaft speed sensor circuit where is it located both input and output speed sensor are located on the left side of the transaxle case. do not interchange input and the output sensor.

...turbine/input shaft speed sensor A circuit Could be any one or more of these problems,but the only way to know sure is to take it in to a transmission shop.Common Problems That Trigger the P0715 Code ...