turbine shaft.Support the engine with a suitable jack stand before removing the transmission from the engine. 5.0L and 5.7L Gasoline Engine: Remove the studs and bolts securing the transmission to the
...Turbine shaft oil seal rings (619) for cut or damaged. Turbine shaft check valve retainer and ball assembly (617) is in place in the end of the turbine shaft and has not come out and gone inside the ...
...on 2004 chevy surban That depends on WHICH speed sensor you want to change. The Vehicle speed sensor? a front wheel speed sensor? A rear wheel speed sensor? an input shaft or turbine speed
Question about 2010 Malibu
...turbine input shaft speed sensor go on a 2010 cevy malibu Lt MY car seems to have trouble identifying in what gear it needs to be in.Had it put on Diagnostic and it read the Turbine input shift speed ...
Question about 2008 Malibu LTZ
Where is turbine shaft speed sensor located on 2008 Chevy Malibu LTZ 3.6L Inside the transmission.
...turbine shaft speed (TSS) sensor ---no signal====causes ---wiring---TSS sensor---ECM/TCM logically the TSS reports to the TCM to facilitate ratio changes so if the wiring , connections etc are not ...
Question about 2007 Silverado 1500 2WD
...p 0717 refers to turbine shaft speed (TSS) sensor---no signal===causes --wiring ---TSS sensor ---ECM----TCM check for wiring and connections at the box-terminals and pins free of corrosion replace ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions