Questions & Answers for: Plymouth Breeze turbine sensor

Question about 1997 Breeze

1 Answer

bad cam or sensor Could you explain how it could be a bad cam or cam sensor? Check this out.. The cam sensor wires and the Ignition coil wires CAN interchange.. If you reverse them.. It'll blow the ...

Ad

Check Engine light came on and car stalled Check engine light stays on i had a code reader on it and the garage said it was the crank sensor after the code reader was on the light stayed off but ...

Ad

i have a 2000 plymoth breeze with no power to the coil have replaced the computer,crank ,and cam sensor what else could it be have you checked timing belt?it may be broken..engine controller must see ...

where is the crank sensor located on 1999 plymouth breeze, 2.4 l double overhead cam? The crankshaft sensor is behind the crankshaft pulley or harmonic balancer. You can access this by pulling off ...

Question about 1998 Breeze

1 Answer

How to replace the oxygen sensor ? Removal & InstallationDisconnect the negative battery cable. On Cirrus, Stratus, Sebring convertible and Breeze models, disconnect the negative battery cable at ...

Check engine diagnossis was the heater sensor. Is 1998 plymouth Breeze 128K miles. Check engine light diagnosis was the heater sensor. The guy didn't give me a code. Is this major. Forgive my ...

Question about 1997 Breeze

1 Answer

Vehicle has poor idle and dies. Only codes are for oxygen sensor short. Data stream is normal except for o2 sensors not switching and when symptom occurs map sensor reads low and vacuum is low but ...

Question about 1998 Breeze

1 Answer

need to put on camshaft postion sensor on a 1998 plymouthbreeze how to If you have the 2.0 SOHC the sensor will be on the right side(driver side) of the valve cover just underneath all those wires ...

Where the temperature sensor on a 98 Plymouth breeze 2.0L is here--- 2.4L below...Hope this helps you?? It all depends on which temperature sensor you are looking for. There is a battery temperature ...

...P0700 and P0715? replaced turbine input speed sensor Hi,po700 is, transmision control system (mil request ) po715 is, turbine/input shaft speed sensor circuit, hope this was some help,all the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...