Questions & Answers for: Mazda Millenia turbine sensor

Question about 2001 Millenia

1 Answer

turbine speed sensor circuit malfunction. which is more likely to cause my car to down shift in the middle of me driving it? THE TURBINE SPEED (PART OF THE TRANSMISSION CONTROLS) SENSOR IS THE CULPRIT

Ad

Question about 1996 Millenia

1 Answer

were is the knock sensor located it is in the water jacket of engine block, before you change this just thought that u should know that the sensor is likely not the problem, the code only means a ...

Ad

2002 mazda millenia mass air flow sensor clean mass air flow sensor where is this sensor located on the mazda millenia 2002 2.5L? MASS AIR FLOW SENSOR IS ATTACH TO AIR DUCT TO AIR CLEANER HOUSING. ...

where is bank 2 sensor 1 oxygen sensor on a 2001 mazda milinia s In a V6 or V8 engine the driver's side cylinders are one bank and the passenger side, the other bank. I would imagine "Bank 2" is the ...

Question about 1995 Millenia

1 Answer

I hooked obd11 up and it gave me po130,po140 andp1522 ,wher are all of this at thank you P1522 VRIS Solenoid '2 Circuit P0130 Oxygen Sensor Circuit Malfunction (Bank 1 Sensor 1) P0140 Oxygen Sensor ...

check engine light dont come on but is throwing multiple code misfiring in 1,3, and 4 cylinder says o2 sensor no activity and crank position sensor a circuit where is crand position sensor located 100

Question about 1997 Millenia

2 Answers

I have a P1170, and a P1195 What are these two codes? P1170 HO2S Bank 1 Sensor 1 Circuit Fixed (Bank 1 Sensor 1) The ECM (engine control module) is getting a low or no signal from the front oxygen ...

where is the oxygen sensor? and is there more than one/ O2 sensor is after catalytic convertor and only one and most never goes bad, just needs cleaned. YOU HAVE TWO OXYGEN SENSORS.ONE OXYGEN SENSOR ...

Question about 1998 Millenia

1 Answer

turbine speed sensor If you were replacing a speed sensor on a 1998 Mazda 626 where would it be located?You can find the vss by going under the car, on backside of transmission facing the floorboards.

1999 mazda millennia wont start showed p1345 code is there a way of testing the camshaft position sensor you can test the cam shaft sensor ,but you will need a lab scope. depending on what type of ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...