Questions & Answers for: Ford Windstar turbine input shaft speed sensor

Question about 1996 Windstar

1 Answer

...and remove cowl cover the wiper mtr will come with cowl cover. once you have done that the coil pack is easy to get to. there are two speed sensors input and output one will be right side tail ...

Ad

...turbine speed sensor need to replace, where is it and should I do it. turbine speed sensor is the torque converter speed ,but where and how it works i do not know,i would buy a manual vehicle nyself ...

Ad

Question about 2000 Windstar

2 Answers

...broken if so replace shaft this is were the speed is checked and sent to your dash. Note - if you remove the broken ring and not replace the shaft your speedo will be out by half doing 50 Km = 100 ...

Question about 1998 Windstar

2 Answers

...Turbine Shaft Speed (TSS) SensorRemoval and Installation Disconnect battery ground cable (14301) and positive battery cable. Refer to Section 14-01. Raise and suitably support vehicle on hoist. Refer ...

Question about 1998 Windstar

1 Answer

...Speed Error P0112 Intake Air Temperature Circuit Low Input P0113 Intake Air Temperature Circuit High Input P0133 02 Sensor Circuit Slow Response (Bank 1 Sensor 1) P0420 Catalyst System Efficiency ...

Question about 1999 Windstar

2 Answers

...shaft. This sensor provides input to the speedometer on instrument cluster. There are also 4 wheel speed sensors (one on each wheel). Their primary function is to detect wheel speed to control ABS. ...

...shaft and swapped the trans. fluid and put on a new filter. Now my vehicle will not go into any gear selection but Reverse. I have one code p0720- where the input isn't matching the output ...

...Sensor Circuit Low Input P0179 Fuel Composition Sensor Circuit High Input P0180 Fuel Temperature Sensor A Circuit Malfunction P0181 Fuel Temperature Sensor A Circuit Range/Performance P0182 Fuel ...

...Input/Turbine Speed Sensor "A" Circuit What does the code mean? OBD-ii Code P0715 definition: The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission ...

...turbine speed sensor located on 98 windstar 3.0 code PO715 it is a sensor that measures the speed of the shaft of the converter into the transmission so it will be at the front of the box it will be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Windstar
1998 Ford Windstar

1,830 Questions

2001 Ford Windstar
2001 Ford Windstar

1,838 Questions

2000 Ford Windstar
2000 Ford Windstar

1,503 Questions

1999 Ford Windstar
1999 Ford Windstar

1,212 Questions

2003 Ford Windstar
2003 Ford Windstar

1,032 Questions

Manuals & User Guides

Loading...