Questions & Answers for: Ford Five Hundred turbine input shaft speed sensor

my abs lights came on along with the parking brake light and the check brakes and also the engin and wrench light are all on!! now the spedo is jumping up and down and at times goes all the way down ...

Ad

Question about 2005 Five Hundred

2 Answers

...UP WHAT DOES THAT CODE MEAN The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor. P0715....Input/Turbine Speed Sensor ...

Ad

Question about 2005 Five Hundred

1 Answer

speed can you recommend a fix. 02 sensor is stuck lean ( bank 1 sensor 1 )--bank 1 is the side for # 1 cylinder. oxygen sensors usually wear out at between 80.000 and 100.000 miles. sensor 1 refers to

...input TR sensor signal is below threshold of 0.127 volts, sensor/circuit electrical malfunction TR sensor indicates a stuck position (D-3rd gear), no adaptive or self learning strategy. Install a new ...

2006 ford five hundred speedometer not working at 55-60 mph speedometer stops working, and mileage odonometer i would try a speed sensor that would be the signal for both speedo and odonometer 

...shaft position sensor in a 2007 Ford Five Hundred My check engine light came on and computer said I had a malfunction on my camshaft sensor. The part is easy to get, I just need to know where it is ...

Question about 2006 Five Hundred

1 Answer

...speed sensor but now have abs light and check engine lights on. How can I reset the computer? One of 2 ways. Disconnect the battery for 10 minutes to clear the brain or go to a Big Three autoparts ...

Question about 2005 Five Hundred

1 Answer

...speed sensor located? 2005-2007 Ford Five Hundred Speed Sensor - JC Whitney www.jcwhitney.com/2005...ford-five-hundred/...speed-sensor...speed-se... Shop for a 2005-2007 Ford Five Hundred OE ...

Question about 2006 Five Hundred

1 Answer

...sensor is an input to the powertrain control module (PCM) and is used to determine the torque demand. There are 3 pedal position signals in the sensor. Signal 1, APPS1, has a negative slope ...

...shaft speed (OSS) sensor Speed control switches Stoplamp switch Speed control deactivator switch SJB messages The outputs of the PCM for the speed control system are: Speed control indicator lamp ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...