Questions & Answers for: Ford Explorer turbine input shaft speed sensor

...input and output turbine shaft speed sensors, this can be a slipping trans, you may not even fell it, but it is indeed slipping, but lets not get ahead here, go to the Ford dealer and have a system ...

...Input/Turbine Speed Sensor Circuit Malfunction in your transmission. It indicates one or more of the following: an open or short in O/D direct clutch speed sensor circuit# 1 vehicle speed sensor ...

input and output shaft speed. In the A4WD (C-Trac) system, the GEM varies the torque sent to the front driveline by controlling the transfer case clutch. At rest and under cruising conditions, the GEM

Location of input speed sensor on 98 explorer automatic it is located on the output shaft housing of the transfer case. hope this helps and dont forget the thumbs up. cheers

...input turbine speed sensor located at,and what does it look like. engine 4.0 overdrive 4x4,i think th trans may be a 55r5e not sure tho. The turbine shaft speed sensor is located inside the ...

input turbine speed sensor. code po715 was pulled on the obd scanner.does any 1 no were this sensor is located at on my transmission, i beleiv e it has the 55r5e trans but not quit sure. engine is a 4

input and output shaft speed. In the A4WD (C-Trac) system, the GEM varies the torque sent to the front driveline by controlling the transfer case clutch. At rest and under cruising conditions, the GEM

...Turbine shaft speed (TSS) sensor fault (Crown Victoria, Expedition, Explorer, F-150 4.6L and 5.4L, Grand Marquis, LS, Mountaineer, Mustang 4.6L automatic, Thunderbird, Town Car). Anti-lock brake ...

...turbine input sensor for a 5R55S transmission? it has a 5R55S transmission and is also getting a P2106 code as well can one be cuaseing the other P2106 - Throttle Actuator Control System - Forced ...

...turbine shaft speed sensor with the part no. 96GT-AC 7M101 work as a replacement for part no. 95GT-AA 7M101. This is for the 4r55e tranny that I'm asking the question about The simple answer is No ...