Question about 2002 Concorde
...speed sensor is an input to the PCM - engine computer ,this is what is used for the vehicle speed info. most of the time ,some vehicle use an input from a wheel speed sensor for the ABS . Looking at ...
my car stay in 2 gear wont shift into other gears turbin speed sensor has went bad there are 2 need to take somewere and have computer scanned to see wich one is bad could be both
Question about 1994 Concorde
...2.5 (normally my speed would be at least 65mph). well what you need is to replace the two sensor on the trans the input and the output speed sensors they less than $30 each and the car will shift ...
...speed or input speed. Rec. replace speed sensors or pull code and properly diagnose vehicle. Limp in is second gear on this car so thats why rpms are high, its only meant to still be able to move car ...
...input speed sensor,they should always be done in pairs and i have had both of them bad on numerous vehicles,hope this helps Change both sensors at the same time. Once you change that, have the ...
...it acts like it is shearching for a gear and goes for one gear and trys to get the next but cant and goes back to the other gear. if u have codes in ecm find the codes most ime is input turbine ...
...entire time driven it is going in limp mode, if your speedometer is not working will cause this,that would be a speed sensor,or the other two reasons would be the input or output sensors on the ...
...of shifting you need to have three sensors checked on the transmission,output sensor,input sensor,and speed sensor, one is not telling the computer your speed,so the computer keeps you in limp ...
speed sensor) NOT input sensor Thanks for choosing FixYa and welcome to the site. Since your check engine light just came on, the computer probably has picked up the problem and stored it. You need to
Usually answered in minutes!
439 Questions
405 Questions
313 Questions
291 Questions
285 Questions
