...turbine speed sensor & abs sensor in diff, still has same problem Be sure to check the vss (vehicle speed sensor) at the output shaft as it's a major input for both engine and transmission. This ...
...input shaft/turbine speed against the speed of the output sensor it is checking to see how much slip or diffrenece in shaft speeds the only time the two shafts are spinning at the same time is when ...
...turbine(input)shaft speed sensor, turbine(output) shaft speed sensor, or the transaxle range sensor, which i found out only comes from ford. where should i start? With the basics you don't state make ...
...UP WHAT DOES THAT CODE MEAN The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor. P0715....Input/Turbine Speed Sensor ...
Question about 2000 Explorer
...input turbine speed sensor located at,and what does it look like. engine 4.0 overdrive 4x4,i think th trans may be a 55r5e not sure tho. The turbine shaft speed sensor is located inside the ...
...take off? Have changed the oxygen sensors, plugs, air filter, catalytic converter, throttle position sensor, and the turbine input shaft speed sensor fuel pressure sensor/regulater its vacuum ...
...715 where is it ? everything I can think of output replaced cant find input? that is the input/turbine speed sensor circuit malfunction. or turbine shaft speed sensor. it tells the car when to
Question about 2010 Mustang
...turbine/input shaft speed sensor located on a 98' Ford explorer sport? Turbine Shaft Speed (TSS) Sensor The turbine shaft speed (TSS) sensor is a magnetic pickup that sends the powertrain control ...
Question about 2010 Mustang
...turbine/input shaft speed sensor located on a 98' Ford explorer sport 6cyl shod 2wd? Turbine Shaft Speed (TSS) Sensor The turbine shaft speed (TSS) sensor is a magnetic pickup that sends the ...
...Turbine input speed sensor. I have 03 Ford Escape XLT 3.0L V6 with a/t front wheel drive and just changed error code P0715 turbine input speed sensor and it's still showing that error code and rpm ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions