Questions & Answers for: Mazda trunk light Cars & Trucks

...tell me that my problem is not with the power trunk solenoid directly. Please can you shed some light on this situation for me. Thanks Blake Check your glove compartment for a trunk shutoff

Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.

...light fuse. Solution: wire going to rear lights was worn and frayed where it feeds through the left trunk lip on left side of trunk. This can be seen when you open the trunk lid. The wire routes by ...

light. Reassemble in reverse order. Put nuts on taillight assembly, snug up. I found I could loosen the nuts by just holding the socket in my fingers, so only tightened the same way, no wrench. Smooth

...trunk to gain access to the light. Usually this includes the piece that runs across the rear body panel. this will be where the trunk latch is. after this is out the side will pull toward the middle ...

...it working and is getting fire through it, i would use oam meter or test light, if it is not check fuses if it is check for fire at trunk release if it has fire change electric lock.. (dealer

...light from the outside in.there is also a plug that is in the floor of the trunk that is used to drain any liquid out by removing it,check and make sure it is in properly.if you find an area,you can ...

Rain water is getting in, through my trunk I believe, and soaking my back seat. its along way from the trunk to the back seat. check the back window,and the doors, get a water hose and have someone ...

trunk light switch The trunk light turns on when the trunk is opened, but turns off when the lid gets about half way open. I assume there is a mercury switch somewhere in the trunk, but I can't ...

trunk light switch/sensor located in a 1999 mazda 626 I am not sure where the switch is located ... but I had generic trunk lid light issues on an older car. It turned out NOT to be a switch issue ...