...troy bilt pony rear tine tiller Trans oil! 90 or 140 wt. I use 140 in my older tiller. G 80W90 Gear oil goes in the tranny. 30W is for the engine only, recomended oil is Briggs & Stratton 30W Engine ...
Question about Bilt Pony 6.5 Hp Rear Tine Tiller
Troy Bilt transmission is 140 Gear Lube. It's tough to find. If you use lighter oil, the trans seals will likely start to leak. Use straight 140w G-4 gear oil. Oriely Auto parts carry it in one gallon
Question about Bilt Pony 6.5 Hp Rear Tine Tiller
...gear oil, API service, GL-5. Is this okay to use? Thanks, Bill OReily Auto parts stores carry GL-4 straight 140W gear oil that will work for the old Troy Bilt tillers. Its around $12.00 a
Question about Bilt Pony 6.5 Hp Rear Tine Tiller
...Troy Bilt 5.5 hp and I got the left side off but the right side tine attachment will not budge any suggestions please Have you tried soaking the shaft area with either PB Blaster or Deep Creep ...
...troy-bilt junior model tiller, and have never had an owner's manual. I noticed the gearbox appears low on oil. What weight oil does the transmission take? these take 90 weight gear oil. SAE 80W90 is ...
Question about Bilt Pony 6.5 Hp Rear Tine Tiller
what kind of oil do you put in the gearbox of a 15 year old pony tiller Hello. The older models use SAE 90 or SAE 140 weight gear oil. joe please rate my answer as very helpful. Thanks. Joe
...troy-bilt junior model tiller and have never had an owner's manual. I noticed the gearbox appears low on oil. What weight oil does the transmission take? You should use straight 140W gear oil. I get ...
Question about Pony Garden Tiller
...straton engine nee... Does a tiller with a briggs and straton engine need just gas or gas and oil mix The pony tiller with a Briggs and Stratton engine only uses gas do NOT mix oil with the gas. ...
...pony use 50 weight for tiller transbox My tilter will not let me adjust the speed. It goes along just fine for a while then all of a sudden it's like it goes into high gear. My varible speed leaver ...
...transmission Troy-Bilt says that if adding a few ounces only, use GL-4 or GL-5 gear oil. If refilling an empty transmission, use GL-4, with a viscosity of SAE 85W-140 or SAE 140. Best regards,
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions