Question about Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966
...troy-bilt weedeater to replace the line. the black piece in the middle is spring-loaded, and the head rotates around it. i can't seem to figure out how to take any of it apart in order to replace the ...
Question about Bilt Tb425cs 26cc 4 - Cycle Curved - Shaft Gas Trimmer with Ez - Start and Speed Spool
...troy bilt trimmer HOW DO I PUT NEW STRING ON MY TB425CS TRIMMER? there are two ways to install the string..the cool way is without pulling the inner reel off the trimmer..just leave it in place..cut ...
...bump knob off to change the line can you help? Hi The Knob should turn to right and not to left as ordinary screwing . If you are turning it the right way and still no luck try hummering slightly on ...
...each one and hold them side by side and wind them onto the spool in a clockwise manner. This is how I do the string head with a split boom that fits the 32cc Sears Power head (an older Troy
Question about Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966
...line. Lift out the spring underneath the spool. Take out the slide washer. Unscrew the arbor bolt either clockwise or counterclockwise, depending on model, in the center of the trimmer head using the ...
Question about Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966
...line read, when I try to remove the retaining knob it just spins. How can I remove the reel and head. I'll send you a link to the operators manual. To change the cable, simply unscrew the bump feed ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions