Question about TX-DS474 Receiver
...output All the other speaker and line outputs work fine. I have followed the programming and troubleshooting instructions in the Instruction Manual and also did the microprocessor reset ...
...to this white resistor 0.22 ohms x2 should also be replaced.(7)plug the amp(8)switch it on(9)if ok, troubleshooting get done(10)if not ok(11)replace ALL the components of this power amp ...
Question about TX-DS797 Receiver
...me now, even though the receiver is 5 years old now.... This type of repair falls into the "major troubleshooting" category, as it has not failed completely and it might take hours to track down
...by the bass audio signals entering via RCA cable from your audio source. Maybe your future troubleshooting would best be served by buying a Digital volt/ohmmeter. I'd check for continuity in ...
this white resistor 0.22 ohms x2 should also be replaced. (7)plug the amp (8)switch it on (9)if ok, troubleshooting get done (10)if not ok (11)replace ALL the components of this power amp channel. (12
...troubleshoot anything with the volume at or near maximum. Look for a mispositioned Mute or tape Monitor control. 1.Always connect TWO speakers to the main output 2. check to make sure you have cross ...
...internally was damaged. Here is a link to the manual for your unit. Page 82 has an excellent troubleshooting section. ...
...Let me know if the problem continues. The first link below will bring you directly to the troubleshooting guide if you need to continue forward with the same error. Additional information ...
...stereo speakers and without any speakers. No diference. Seems like a protection starting to work,but there is no shortcuts or overheating. Thanks. If the receiver goes into protect mode with no ...
Usually answered in minutes!
269 Questions
261 Questions
161 Questions
135 Questions
85 Questions