Questions & Answers for: Pontiac Grand Am trim

Question about 2002 Grand Am

1 Answer

...switch? Is that a fuse? The hazard switch replaced as a complete unit. You have to remove the trim around your radio that the switch sits in. Apply the park brake. Adjust the shift lever to

Ad

...and Connection in Engine Electrical. Remove the upper and lower shrouds. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle or Steering Column Trim Covers - Disassemble - Off Vehicle

Ad

...ignition module? if you take your time, you can do it!! disconnect neg, battery terminal, remove trim around switch, the trim pulls out from dash. remove the 2 screws holding it in. push the

...Am 2-Door. Water runs into back floor when it rains. There is a trail of water on the kick plate trim. Is this a door gasket problem? The trim doesn't look torn anywhere. it could be a wids screen ...

I had my windshield replaced recently, they only replaced the top and bottom trim around the windshield. I need the trim for on the side of the windshield, no idea where to find it. 2001 pontiac grand

...under the hood. 4 Locate your adjustment screws. On sealed beam units, you may need to remove the trim screws and pull the trim off to reveal the Torx screws. 5 Begin with you headlights turned on ...

Question about 1999 Grand Am GT

1 Answer

...& Air ConditioningDisconnect the negative battery cable. Remove the screws securing the cluster trim plate to the instrument panel. Tilt the top of the cluster trim plate downward releasing the ...

Question about 1994 Grand Am

1 Answer

...to remove from lever. On all models, carefully pry upward on outer edges of console trim plate. Disconnect electrical connectors and ashtray lamp from console trim plate, then remove ...

Question about 2002 Grand Am

2 Answers

...for using FixYa. Disconnect the negative battery cable. Remove the screws securing the cluster trim plate to the instrument panel. Tilt the top of the cluster trim plate downward releasing the ...

Question about 2001 Grand Am SE

2 Answers

...blinker relay is getting worn out. It's right behind the hazard lights switch. Pull off the black trim around the radio, hazard, ets, and the relay is write there. Next time the blinkers stop ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...