trigger lock locks backwards When the trigger lock is engaged you can not pressure wash . Is this backwards or is it just me It's just you...! Because the high pressure jet is potentially a dangerous ...
Question about Phantom .177 Caliber Break Barrel Synthetic Stock Air Rifle
...lock on the trigger. if trigger is adjustable set adjustment more coarse. Check also sure that trigger mechanism is in forward position and not stuck halfway. If still not hooking see if piston hooh ...
Question about PSI Electric Pressure Washer
Karcher K 3.68M Electric Pressure Washer. Wand trigger Locks Up. Karcher K 3.68M Electric Pressure Washer. Working fine, then the wand trigger would not depress. Could find no blockages. When turned ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
...trigger lock ( dead man ) to remove the trigger lock, gently pry the two halfs of the tank apart at the rear opening where the lock sits, this will allow the back end of the throttle lock to pop up, ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
...trigger lock on a recip saw is a safety device that is there so the trigger switch will not work unless the lock is pressed first. If the lock doesn't work the saw will still work properly, it just ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
...trigger and lock out lever comes as a kit, part no. 530071305, remove the top cover, depress the trigger and pry up the throttle wire away from the trigger, knock out the two roll pins, drop the ...
...all of the sudden stuck down... help? Check for a trigger lock/bar that slides up or down to unlock trigger. If no lock, take a small flathead screw driver and jiggle it in the back of the
Question about Pneumatic Stapler
...trigger lock on an early EL-1 Ser# 001191 Remington Limb N Trim electric saw. I bought this saw and I can find NO external button to lock out trigger, or safety button/release. The trigger was in a ...
Question about Pneumatic Stapler
...trigger lock doesn't work to allow you to turn on. What are we doing incorrectly? The saw may have an interconnect between the choke and the trigger lock, however unlikely. Set the choke, pull in the ...
Question about Pneumatic Stapler
...trigger lock is pressed and the trigger released. The lock will hold the throttle partway open; freeing both hands to hold the tool steady and pull the starter. The partway open throttle makes ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions